Good day for GPWS
#31
Gets Weekends Off
Joined APC: Mar 2015
Posts: 328
Part of being PIC is making the call to refuse an aircraft that has an operational MEL if the situation warrants it. If I'm going into mountainous terrain, at night, in the wx, you can be damn sure I'm not going without a GPWS.
#32
I agree with this. In MANY airports in the US, I've been cleared down to the MVA, then told to cross a fix 1000 feet below its charted altitude restriction. Within radar contact, if ATC clears you to cross a fix at or below a certain altitude, in the US, this assures terrain clearance. While the crew *SHOULD* have done a better job of cross-checking the clearance, it is not their solely their fault. ATC holds the lion's share of the blame in this situation. With as much responsibility as they have placed on our shoulders over the last decade with regards to charted procedures, I'm not surprised this has happened. All the guy had to do was clear them to the IAF and then cleared for the approach. Issuing an altitude is a completely unnecessary piece of information, unless of course he intended them to descend to the bottom altitude at CEGAN.
First of all - anyone in 121 ops receiving a clearance to fly a full, No-PT arc to a vor/dme-C in the mountains needs to have their guard up. I think their eventual choice to get the ILS should have been exercised upon arrival looking at the wind trend.
But, they decided to accept the VOR. Okay, fine. But, when that clearance comes in, how can anyone flying a modern FMS equipped jet not have at least a couple of HUGE question marks over their heads? They're flying a published approach.
#1 - 7800 MSL isn't even a depicted altitude on the approach.
#2 - Why would ATC give a clearance that may require us to climb after we've already descended (I say "may" because they did have the option to stay at or above 10K)
This stuff about some RJ drivers being instinctively prone to comply and ask questions later is nonsense. Little boys worrying about making ATC mad need to grow up, put their big boy pants on and figure it out.
We input the approach in the box, check the points/altitudes and brief, with someone cross-checking the box with the plate. At some point, you would think they had to at least discuss the fact that the lowest altitude on the arc from CEGAN to BRKET was 10,000. So, they either comply with their clearance but stay at/above 10K until starting the lead turn off the arc, realizing that ATC set them up or they CLARIFY.
But, since neither of those two options were exercised, it seems pretty clear that these two guys were grossly unfamiliar with the approach they just accepted a clearance to fly. I obviously can't say for sure, but it seems like a reasonably conclusion that they didn't brief and didn't cross-check FMS inputs. If they did either of these two things, I find it hard to understand how they got to the point of a GPWS alert.
All that said, this ATC controller was an idiot. Someone needs to educate him on the huge difference between legal and smart. Combining an unrelated MVA with a clearance to begin a full-up instrument procedure from a distant IAF may be legal (don't know for sure) but it's certainly not a good practice. We get tested enough on a daily basis from threats we can't control or minimize. We don't need ATC throwing out random Easter eggs because they're too lazy to use an appropriate altitude for a VOR clearance instead of just grabbing the MVA off their screen.
Last edited by Adlerdriver; 01-30-2018 at 01:27 PM.
#33
Adlerdriver,
Then again, I’ve seen pilots, 250nm from the destination, act as if the descent clearance is a command and never ask, “do we need start now” or “can we make that, ‘when ready, descend’”.
GF
Then again, I’ve seen pilots, 250nm from the destination, act as if the descent clearance is a command and never ask, “do we need start now” or “can we make that, ‘when ready, descend’”.
GF
#34
Disinterested Third Party
Joined APC: Jun 2012
Posts: 5,926
John,
I agree and the controller, if using MVA, had, by policy, to have the arc displayed on the video and monitored the flight progress. Certainly, the latter was not done. I’m not arguing the controller was correct, just a very narrow read of .65. Pilots always need to assume terrain clearance responsibility, if only, because they die if they’re wrong.
GF
I agree and the controller, if using MVA, had, by policy, to have the arc displayed on the video and monitored the flight progress. Certainly, the latter was not done. I’m not arguing the controller was correct, just a very narrow read of .65. Pilots always need to assume terrain clearance responsibility, if only, because they die if they’re wrong.
GF
At the end of the day, the controller goes home to sleep in his own bed. This is not always true of the crew and contents.
#35
Gets Weekends Off
Joined APC: Jul 2013
Posts: 9,940
No. This crew gets no slack. It was a poorly crafted, no-sense clearance and they shouldn't have accepted it or simply complied with the non-precision approach for which they were cleared (since the at or above clearance gave them that latitude).
First of all - anyone in 121 ops receiving a clearance to fly a full, No-PT arc to a vor/dme-C in the mountains needs to have their guard up. I think their eventual choice to get the ILS should have been exercised upon arrival looking at the wind trend.
But, they decided to accept the VOR. Okay, fine. But, when that clearance comes in, how can anyone flying a modern FMS equipped jet not have at least a couple of HUGE question marks over their heads? They're flying a published approach.
#1 - 7800 MSL isn't even a depicted altitude on the approach.
#2 - Why would ATC give a clearance that may require us to climb after we've already descended (I say "may" because they did have the option to stay at or above 10K)
This stuff about some RJ drivers being instinctively prone to comply and ask questions later is nonsense. Little boys worrying about making ATC mad need to grow up, put their big boy pants on and figure it out.
We input the approach in the box, check the points/altitudes and brief, with someone cross-checking the box with the plate. At some point, you would think they had to at least discuss the fact that the lowest altitude on the arc from CEGAN to BRKET was 10,000. So, they either comply with their clearance but stay at/above 10K until starting the lead turn off the arc, realizing that ATC set them up or they CLARIFY.
But, since neither of those two options were exercised, it seems pretty clear that these two guys were grossly unfamiliar with the approach they just accepted a clearance to fly. I obviously can't say for sure, but it seems like a reasonably conclusion that they didn't brief and didn't cross-check FMS inputs. If they did either of these two things, I find it hard to understand how they got to the point of a GPWS alert.
All that said, this ATC controller was an idiot. Someone needs to educate him on the huge difference between legal and smart. Combining an unrelated MVA with a clearance to begin a full-up instrument procedure from a distant IAF may be legal (don't know for sure) but it's certainly not a good practice. We get tested enough on a daily basis from threats we can't control or minimize. We don't need ATC throwing out random Easter eggs because they're too lazy to use an appropriate altitude for a VOR clearance instead of just grabbing the MVA off their screen.
First of all - anyone in 121 ops receiving a clearance to fly a full, No-PT arc to a vor/dme-C in the mountains needs to have their guard up. I think their eventual choice to get the ILS should have been exercised upon arrival looking at the wind trend.
But, they decided to accept the VOR. Okay, fine. But, when that clearance comes in, how can anyone flying a modern FMS equipped jet not have at least a couple of HUGE question marks over their heads? They're flying a published approach.
#1 - 7800 MSL isn't even a depicted altitude on the approach.
#2 - Why would ATC give a clearance that may require us to climb after we've already descended (I say "may" because they did have the option to stay at or above 10K)
This stuff about some RJ drivers being instinctively prone to comply and ask questions later is nonsense. Little boys worrying about making ATC mad need to grow up, put their big boy pants on and figure it out.
We input the approach in the box, check the points/altitudes and brief, with someone cross-checking the box with the plate. At some point, you would think they had to at least discuss the fact that the lowest altitude on the arc from CEGAN to BRKET was 10,000. So, they either comply with their clearance but stay at/above 10K until starting the lead turn off the arc, realizing that ATC set them up or they CLARIFY.
But, since neither of those two options were exercised, it seems pretty clear that these two guys were grossly unfamiliar with the approach they just accepted a clearance to fly. I obviously can't say for sure, but it seems like a reasonably conclusion that they didn't brief and didn't cross-check FMS inputs. If they did either of these two things, I find it hard to understand how they got to the point of a GPWS alert.
All that said, this ATC controller was an idiot. Someone needs to educate him on the huge difference between legal and smart. Combining an unrelated MVA with a clearance to begin a full-up instrument procedure from a distant IAF may be legal (don't know for sure) but it's certainly not a good practice. We get tested enough on a daily basis from threats we can't control or minimize. We don't need ATC throwing out random Easter eggs because they're too lazy to use an appropriate altitude for a VOR clearance instead of just grabbing the MVA off their screen.
And like I said before, one of the biggest problems is that we so often get vectors for the approach, a lot of pilots get confused (their fault) on vectoring for a final and full approach procedures. We are so used to getting clearances to descend below platform altitudes that most don't even flinch anymore...like driving it in at 4000 feet over Lake Michigan to O'Hare or being 20 miles out of ATL and getting 3000 feet (not depicted on any platform).
#36
If ATC had vectored them into a GPWS alert trying to get them onto a portion of the approach down track, then I would agree the blame should be shared.
The only reason I even threw a single spear in the direction of ATC was because he actually came back and defended the dumba$$ clearance he gave them. If he had acknowledged the altitude limit he provided made no sense and it was a mistake, I'd have nothing to say about him (other than it was a human error that caused confusion).
But we get confused by ATC regularly. We do the same to them. That's why we use the feedback loop and clarify as necessary. The one nice thing about being cleared to proceed direct to an IAF and cleared for the VOR/DME-C is that the communication is done. The restrictions, routings and mins are all there in black and white with no requirement for further communication until we switch to tower. This was a procedural error on the part of this crew who somehow arrived at that point in their career with the mistaken impression that ATC could lower a depicted IAP altitude restriction over VHF. The error is all theirs, IMO.
#38
Sure, I can understand how this happened too. It appears that ATC instructions were perceived as the gospel even though they directly contradicted the printed information on the IAP the crew was cleared to fly.
So, these two pilots either believed ATC could clear them to start an IAP from the IAF at an altitude lower than published...or
They were unaware of the published minimum altitude on the arc.
Both of those situations are unacceptable in my opinion and point to a perception and/or procedural failure on the crew's part.
It would appear the problem is assuming ATC is infallible and blindly following their instructions in the face of very specific and clear published guidance to the contrary. That's my point.
Would you blame ATC or say they at least shared the blame if ground cleared someone to taxi across the grass to get to the gate and they complied? Some things are simply black and white and the pilots are the final quality check.
#39
We are so used to getting clearances to descend below platform altitudes that most don't even flinch anymore...like driving it in at 4000 feet over Lake Michigan to O'Hare or being 20 miles out of ATL and getting 3000 feet (not depicted on any platform).
GF
#40
This should be looked at as two clearances, the first was an enroute dir>cegan which requires an altitude at or above MEA/MCA. In this case MVA was used because they were off route and no MCA existed for the next segment being the IAP.
The second clearance was the for the VOR approach. The crew was responsible for this portion and the controller should be monitoring the progress and altitude, that didn't happen.
A terribly dangerous clearance that still baffles me, and then backed up with the statement, "I gave 7800' or above"? Did ATC really mean that? has he given this clearance before? will he do it again? not likely.
The crew lived to learn a valuable lesson the hard way and we have the comfort of debating their lesson on the keyboard with the hindsight being 20/20.
I'm sure that part of their acceptance of this clearance was the preconditioning from being assigned altitudes below published when being vectored to final. As we all now this happens on a regular basis.
No excuse, just trying to understand how one gets there.
The second clearance was the for the VOR approach. The crew was responsible for this portion and the controller should be monitoring the progress and altitude, that didn't happen.
A terribly dangerous clearance that still baffles me, and then backed up with the statement, "I gave 7800' or above"? Did ATC really mean that? has he given this clearance before? will he do it again? not likely.
The crew lived to learn a valuable lesson the hard way and we have the comfort of debating their lesson on the keyboard with the hindsight being 20/20.
I'm sure that part of their acceptance of this clearance was the preconditioning from being assigned altitudes below published when being vectored to final. As we all now this happens on a regular basis.
No excuse, just trying to understand how one gets there.
Thread
Thread Starter
Forum
Replies
Last Post