Go Back  Airline Pilot Central Forums > Career Builder > Technical
Fix to fix navigation problem >

Fix to fix navigation problem

Notices
Technical Technical aspects of flying

Fix to fix navigation problem

Old 09-03-2013, 06:18 PM
  #1  
Gets Weekends Off
Thread Starter
 
jsfBoat's Avatar
 
Joined APC: Sep 2006
Position: Lovin' life at .4 (ish) mach
Posts: 1,317
Default Fix to fix navigation problem

I'm curious to know if there is, and what is, the method to solve fix to fix navigation problems. I found something in Thai but couldn't translate it. Basically an airplane is on a certain radial at a certain distance and needs to figure out what direct heading will take the airplane to a different radial of the same VOR at a different distance. Appreciate any useful replies. Is there a way to do this on paper without looking at a HSI?
jsfBoat is offline  
Old 09-03-2013, 07:40 PM
  #2  
Gets Weekends Off
Thread Starter
 
jsfBoat's Avatar
 
Joined APC: Sep 2006
Position: Lovin' life at .4 (ish) mach
Posts: 1,317
Default

Using the math method, I used the pythagorean theorem to find the length in NM of the direct route, then Cosine to find one of the unknown angles. This angle was used to find the 3rd angle (180 degrees in total) and this added or subtracted the recripocal of the radial to find the direct heading. If someone has a shortcut I'd appreciate it, but the above was the only method I could come up with.
jsfBoat is offline  
Old 09-03-2013, 08:33 PM
  #3  
Chief Jeppesen Updater
 
FlyerJosh's Avatar
 
Joined APC: Oct 2005
Position: Executive Transport Driver
Posts: 3,080
Default

Personally, I tend to favor the "direct to" button on my FMS. If that's unavailable, then I figure there's a PTT button on the yoke with which I can request radar vectors.
FlyerJosh is offline  
Old 09-03-2013, 10:24 PM
  #4  
Gets Weekends Off
 
Adlerdriver's Avatar
 
Joined APC: Jul 2007
Position: 767 Captain
Posts: 3,987
Default

Originally Posted by jsfBoat View Post
I'm curious to know if there is, and what is, the method to solve fix to fix navigation problems. I found something in Thai but couldn't translate it. Basically an airplane is on a certain radial at a certain distance and needs to figure out what direct heading will take the airplane to a different radial of the same VOR at a different distance. Appreciate any useful replies. Is there a way to do this on paper without looking at a HSI?
The only way I've ever done it is looking at an HSI while flying in an airplane. Isn't that the best way to do it since you need to do it while you're actually flying? You can practice on paper to get comfortable with the method, but how often are you going to know the exact fixes you'll be using when you're not in the airplane? When I was going through UPT in the USAF, our instructors would just give us a fix to fly to and we had to figure it out on the spot while flying the jet.

This method is no-wind and the heading you determine must be adjusted for any known winds. In basic terms, you use your HSI as a god's eye view of the situation and picture each fix on the HSI using a relative scale based on their DME. Then you turn to line up the fixes vertically so your heading is toward the destination fix. I'll assume you have some kind of bearing pointer available on your HSI or RMI to locate the radial you're currently on.

Example: You're on the 120/30 and you want to go to the 030/60 and you're currently heading West. You take the fix with the biggest DME and locate that on the edge of the HSI on the appropriate radial. So, looking at your HSI, the fix you want to go to (030/60) would be around the 4 o'clock position on the HSI at the outer edge. Using that scale, your current position will be on the tail of the bearing pointer half-way between the outer edge and the center since the DME is half of the larger. So, you're halfway from the middle on the 7 o'clock line. Once you have the two fixes located on the HSI, draw an imaginary line between them or even hold a pencil up to line them up. Now move the pencil (without changing its orientation) to the middle of the HSI and read the required heading based on the direction you need to turn (in this case a right turn). My guess would be the heading would be in the ballpark of North, no wind (I'm laying in bed and don't feel like drawing it out).

It's good to update as you fly toward the fix in case your first heading was a little off or winds are a factor. It's best to make your updates at whole number DMEs that are multiples of the larger DME (in this case, 10, 15, 20, etc) that make the math to set the relative scale easier.
Adlerdriver is offline  
Old 09-04-2013, 02:38 AM
  #5  
Organizational Learning 
 
TonyC's Avatar
 
Joined APC: Nov 2005
Position: Directly behind the combiner
Posts: 4,948
Default

Originally Posted by jsfBoat View Post

I'm curious to know if there is, and what is, the method to solve fix to fix navigation problems. I found something in Thai but couldn't translate it. Basically an airplane is on a certain radial at a certain distance and needs to figure out what direct heading will take the airplane to a different radial of the same VOR at a different distance. Appreciate any useful replies. Is there a way to do this on paper without looking at a HSI?


Use the windface of your whiz wheel. Use the center as the VOR, mark the FROM and TO waypoints on the appropriate radials, using a distance scale that will accomodate both points but maximize the detail/accuracy. Spin the wheel to place the TO point directly above (vertically) the FROM point, read the no-wind heading under the top index.






.
TonyC is offline  
Old 09-04-2013, 03:42 AM
  #6  
China Visa Applicant
 
Joined APC: Oct 2006
Position: IPZ to Mr.
Posts: 1,915
Default

Originally Posted by jsfBoat View Post
Is there a way to do this on paper without looking at a HSI?
The USAF method as described by @Adlerdriver is the only one I know of. It requires a little practice, but is actually very effective.

Unfortunately, since the FAA no longer does radial/DME fix-to-fix, neither does the USAF, and this technique is no longer taught.
Hacker15e is offline  
Old 09-04-2013, 03:55 AM
  #7  
Working weekends
 
satpak77's Avatar
 
Joined APC: Jul 2005
Position: Left Seat
Posts: 2,384
Default

Originally Posted by jsfBoat View Post
I'm curious to know if there is, and what is, the method to solve fix to fix navigation problems. I found something in Thai but couldn't translate it. Basically an airplane is on a certain radial at a certain distance and needs to figure out what direct heading will take the airplane to a different radial of the same VOR at a different distance. Appreciate any useful replies. Is there a way to do this on paper without looking at a HSI?
I am all ears to anyone who can tell me where in the real world this example has occurred. I have flown all over South, Central, and North America, radar and non radar, and never been seen it. Not saying it doesn't happen, just saying that I have flown all over South, Central, and North America, radar and non radar, and never been seen it.
satpak77 is offline  
Old 09-04-2013, 07:29 AM
  #8  
Gets Weekends Off
 
galaxy flyer's Avatar
 
Joined APC: May 2010
Position: Baja Vermont
Posts: 5,168
Default

Actually, used it a lot in the USAF, never in civilian flying.

They don't even teach it in UPT anymore? What's Check Section got to say about that? No more students going crazy trying to perfect fix-to-fix NAV problems in a 38.

GF
galaxy flyer is offline  
Old 09-04-2013, 07:38 AM
  #9  
Gets Weekends Off
 
USMCFLYR's Avatar
 
Joined APC: Mar 2008
Position: FAA 'Flight Check'
Posts: 13,835
Default

Originally Posted by galaxy flyer View Post
Actually, used it a lot in the USAF, never in civilian flying.

They don't even teach it in UPT anymore? What's Check Section got to say about that? No more students going crazy trying to perfect fix-to-fix NAV problems in a 38.

GF
I HATED PTP problems!
Thought they was going to down me a few times
Much easier in my fleet aircraft with a planview HSI with selectable ranges and the ability to display courselines.
USMCFLYR is offline  
Old 09-04-2013, 07:46 AM
  #10  
Organizational Learning 
 
TonyC's Avatar
 
Joined APC: Nov 2005
Position: Directly behind the combiner
Posts: 4,948
Default

Originally Posted by satpak77 View Post

I am all ears to anyone who can tell me where in the real world this example has occurred. I have flown all over South, Central, and North America, radar and non radar, and never been seen it. Not saying it doesn't happen, just saying that I have flown all over South, Central, and North America, radar and non radar, and never been seen it.

Never been seen it?

I've only seen it once since the Air Force. It was probably 7 or 8 years ago, in the B-727, heading somewhere in the Northeast, maybe in the neighborhood of Pennsylvania. We were cleared to a radial/DME fix off of a VOR, the FO was confused by the clearance and wasn't sure if we could comply, I assured him we could, we hit the fix within 0.2 NM, and then held.

I had a T-37 student who struggled with Fix-to-Fixes, just had a hard time conceptualizing the process. He managed to consistently apply a method to accomplish the task, but probably never understood it. On his Instrument Check ride, he successfully accomplished the task early in the profile (when the task was assigned by the Check Pilot), then was unexpectedly assigned another fix-to-fix by ATC near the end of the profile. The grading philosophy was "first or worst", so if he aced the first and blew the second, he'd still bust the checkride. He tried to persuade ATC to send him direct to the VOR instead of a radial/DME fix, but ATC would not relent. Finally he asked for a vector. ATC obliged. He passed the checkride.

That's the "real world" solution these days. If your airplane isn't RNAV equipped, it's still vector equipped.






.
TonyC is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
BEWELCH
Flight Schools and Training
43
03-21-2007 09:42 AM
UConnQB14
Hangar Talk
32
01-24-2007 06:24 PM
Tigerpilot1995
Cargo
4
01-14-2007 08:56 AM
groovinaviator
Regional
13
01-08-2007 12:43 PM
KoruPilot
Regional
43
11-04-2006 08:47 PM

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Thread Tools
Search this Thread
Your Privacy Choices